Class 501 - Introduction to Turning A (Fall - October 15) Section 1
October 15, 2023 October 22, 2023
SERIES OF CLASSES
Total # of Classes
2
Class length
300 minutes
Location
Machine Room and Bench Room
Description: In this class, students will learn:
- The safety and basics of turning
- Lathe components and turning tools
- Tool sharpening and use
- How to perform the basic cuts on spindles: V-groove, coves and beads
The class concludes with the student making a tool handle, including the application of a ferrule and a finish. This class will help prepare you to get the certification necessary to use the shop lathes.
Level: Beginner
Prerequisites: Age >18
Format: 2 sessions, 8 hours total (Please note: due to the limitations of Punchpass, the second class appears 5 hours long. It is only 3 hours).
Project you will make: Honey dipper
Cost: $185 and $35 SDFWA membership.
Special Instructions for this class: Review the following videos before class.
Sharpening the Spindle Rouging Gouge
Full refunds for cancelations more than 14 days in advance or if class is cancelled; 50% refunds for cancelations more than 7 days in advance; No refunds for cancelations less than 7 days in advance or for failure to appear.
The class takes place on...
- October 15 at 12:00 pm (Sunday)
- October 22 at 12:00 pm (Sunday)
Reservations
This class series has already finished. Please check our schedule for more classes.